Before starting make sure that the iPhone is off.

Remove the 2 3.6 mm Pentalobe screws located on both sides of the charging connector.

Use the special tool with suction cups to separate the front panel easily.

Just place the iPhone with the bottom towards the tool and adjust the suction cups.

Then press to separate the front panel.

Separate the front panel, leaving the upper part joined by the flex data cables.

Remove the metal shield that covers the connectors on the board. It is held by the following Phillips screws:

• 3 of 1.2mm
• 1 of 1.5mm
• 1 of 2.9mm

Disconnect the flexes from the front panel on the motherboard.

Separate the front panel.

Check if the replacement screen contains the components (camera, headset, home button, ...). If you do not have any of the components, continue with the following steps.

Remove the metal support from the handset, held by 3 Phillips screws:

• 2 of 2.3 mm
• 1 of 1.5 mm

Separate the front camera with the flex and remove the headset.

Carefully remove the sensors and the microphone.

Remove the metal support held by 2 Phillips 1.8 mm screws.

Unplug the connector and, with the flat part of the plastic spatula, take off the flex.

Take off the home button, pressing from the front side.

Remove the 8 screws that hold the metal shield.

The shield carries a flex that connects to the home button. You must carefully take off the bottom part to separate it.