Before starting make sure that the iPhone is off.

Remove the 2 3.6 mm Pentalobe screws located on both sides of the charging connector.

Use the special tool with suction cups to separate the front panel easily.

Just place the iPhone with the bottom towards the tool and adjust the suction cups.

Then press to separate the front panel.

Separate the front panel, leaving the upper part joined by the flex data cables.

Remove the metal shield that covers the connectors on the board. It is held by the following Phillips screws:

• 3 of 1.2mm
• 1 of 1.5mm
• 1 of 2.9mm

Disconnect the flexes from the front panel on the motherboard.

Separate the front panel.

Remove the metal shield covering the battery connector, held by 2 Phillips screws:

• 1 of 2,3mm
• 1 of 3,1mm

Disconnect the battery in the motherboard.

Disconnect the coaxial antenna cable.

Disconnect and remove the flex from the lower load connector module.

Remove the vibrator, held by 2 Phillips screws of 2.5mm.

Separate the coaxial antenna cable.

Remove the 2 Phillips screws that hold the speaker:

• 1 of 2.3 mm
• 1 of 2.8 mm

Remove the speaker.

Remove the metal shield secured by 2 x 3.3 mm Phillips screws.

Disconnect the antenna coaxial cable at the lower end.

Remove the Phillips screws to remove the lower flex:

• 2 of 1.4 mm
• 2 of 3.2 mm
• 1 of 3.8 mm
• 2 of 1.5 mm
• 2 of 1.7 mm

Heat the opposite side with hot air so that the glue softens and separates easily.

Remove the small bracket that holds the microphone.

Carefully peel off the flex, starting at the top.

Separate finally the microphone and audio connector, since these carry a sticker that guarantees the insulation.