Before starting make sure that the iPhone is off.

Remove the 2 3.6mm Pentalobe screws, located on either side of the charging connector.

Use the tool with suction cups to easily separate the front panel (screen + accessories) without damaging the equipment.

The front panel will be attached to the base plate by the data flexes at the top. These flex cables are fragile and can be cut or broken, handle them with care.

Remove the Phillips screws that hold the shield covering the connections on the motherboard:

• 3 screws of 1.2 mm
• 1 screw of 1.7 mm
• 1 screw of 3.1 mm

Remove the shield to access the connectors.

Disconnect the flexes from the front panel on the motherboard.

Separate the front panel.

Remove the metal shield covering the battery connector, held by 2 Phillips screws:

• 1 of 3.2 mm
• 1 of 2.2 mm

Disconnect the battery from the motherboard.

Unplug the flex from the charging module on the motherboard.

Disconnect the coaxial antenna cable.

Remove the 4 Phillips screws that hold the speaker module:

• 2 of 2.9 mm
• 2 of 2.3 mm

Finally, remove the speaker module.