Before starting make sure that the mobile is off.

Remove the 2 Pentalobe screws on the bottom of the iPhone.

For the opening of the iPhone we suggest this tool with suction cups, it is easy to use and will avoid unnecessary damages.

Simply hold the iPhone with the suction cups, just above the "Home" button and press the tool to open it.

If you do not have the suction cup tool, you can also do it manually.

Glue a suction cup just above the "Home" button and pull up while holding and prying the joint with the plastic opening tool.

If you pull too hard you can break the flex cable of the fingerprint reader.

Remove the metal shield covering the flex connector from the fingerprint reader.

Disconnect the flex cable from the fingerprint reader. This will allow you to separate the screen except the upper part, still attached to the base plate by the flex cables.

Remove the metal shield covering the connectors, held by 4 Phillips screws.

Disconnect the flex cables from the motherboard and separate the screen.

Remove the metal shield covering the battery connector, held by two Phillips screws.

Disconnect the battery from the motherboard.

Pull the small black ribbon to remove the adhesive bands that hold the battery.

Once the adhesive is removed, remove the battery.

Replace the adhesive strips to install it again.

Remove the SIM tray.

Remove the rubber that covers the rear camera.

Unplug the camera from the motherboard and pull it gently to remove it.

Remove the metal support from the vibrator, held by 2 Phillips screws.

Remove the Phillips screw from the top.

Remove the vibrator.

Disconnect and take off the lower flex.

Disconnect the coaxial antenna cable.

Remove the 4 Standoff screws (marked in pink) and the 3 Phillips screws (marked in red) that hold the motherboard.

For the Standoff screws we suggest a flat-head screwdriver.

Finally, disconnect the coaxial cable that connects to the wifi antenna on the back of the motherboard.

Remove the metal support held by 2 Phillips screws.

Remove the Phillips screw and the black rubber part that covers the ignition button holder.

Remove the flash backwards, leaving enough space for the power button support.

Move the bracket inwards until there is enough space and remove the button with the clips.

Remove the 3 Phillips screws that hold the volume and lock button holders.

Remove the volume and lock keys with the clamps.

Remove metal dough contact.

Carefully lift the flex out of the housing.

Take off the microphone.

Release the power button holder. It is fastened by a pin like a hinge.

Just push it inwards and pull gently when it reaches 90º to the case.

Finally separate the complete flex.

Carefully remove the WIFI antenna from the housing.