We remove the two Pentalobe screws (TS1) from the bottom of the phone.

We apply heat to the screen to soften the adhesive, and with the help of suction cups and plastic spikes we will take off all the edges of the screen.

We remove the two Triwing screws (Y0.6) that hold the shield and disconnect the battery to work with greater safety.

We remove the six Triwing screws (Y0.6) that hold the shield, and with the help of a flat tool we will disconnect all the connectors from the screen and the headset module.

We remove the three screws that hold the headset module, and lift it.

We disconnect the sensor area, and take it off the screen that we are going to replace with the help of a flat tool.