We remove the two Pentalobe screws (TS1) from the bottom of the phone.
Step 2 Adhesive
We apply heat to the screen to soften the adhesive, and with the help of suction cups and plastic spikes we will take off all the edges of the screen.
Step 3 We disconnect battery
We remove the two Triwing screws (Y0.6) that hold the shield and disconnect the battery to work with greater safety.
Step 4 Display with headset module
We remove the six Triwing screws (Y0.6) that hold the shield, and with the help of a flat tool we will disconnect all the connectors from the screen and the headset module.
Step 5 Upper armor
Remove the four Phillips screws (PH # 00) that hold the upper shield.
Step 6 Components
We disconnect the components that are connected to the motherboard.
Step 7 Components
We finished disconnecting the components from the motherboard.
Step 8 Tray
We remove the card tray.
Step 9 Motherboard
Remove the three female flat screws that hold the motherboard, and we can remove the plate.
Step 10 Cameras
We remove both the front and rear cameras.
Step 11
Remove the screws indicated in the first picture and take off the microphone area.
Step 12 Screws
We remove more screws than we indicated in the first photograph, and take off part of the flex.
Step 13 Flex with power button, flash and microphone
Finally, it is only necessary to remove the two screws that hold the button area.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.