To begin, we must remove the two Pentalobe 0.8 (TS1) screws from the bottom of the housing, apply some heat to soften the adhesive, and with the help of a tool with suction cups we will take off the chassis screen.

We disconnect the battery connector to work with greater safety.

We remove the five Triwing screws (Y0.6) that hold the shield, and once removed we can disconnect the flex from the screen and the headset module.

We remove the three Phillips screws (PH # 00) and the Triwing 0.8 screw (Y0.6) shown in the photographs, and we will take off the headset module and other components of the screen.