Guide with all the steps necessary for you to change the lower flex yourself, for faults in the microphone, vibrator or lower buttons of the Alcatel One Touch Idol Ultra.
Make sure the computer is turned off before you start.
Eject the SIM card by pressing it until you hear "click".
Remove the Phillips screw located next to the USB charging connector.
Separate the cover little by little with a prong all around.
Remove the back cover.
To remove the rear camera, disconnect it from the motherboard and pull it out gently.
Remove the metal shield covering the connectors.
Disconnect the data cable from the display. Remove the Phillips screw that is underneath.
Disconnect the coaxial cable.
Disconnect the flex cable from side keys.
Pull the plate away from the top to gain access to the connectors.
Remove the protective plastic and disconnect the battery cable.
Disconnect the connector on the bottom flex to separate the base plate.
Take off the battery trying not to deform it, as it could damage it.
Remove the battery.
Disconnect and remove the coaxial cable by pulling it.
Although the picture is not shown, it is not necessary to remove the plate or the battery.
Insert the HOT GLASS in the microwave for the time specified in the instructions for use.
If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.
The last minute in the microwave is advised to interrupt every 15 seconds and knead the gel inside with your hands to distribute the heat.
Apply heat to the screen for a couple of minutes.
Insert the tip of the tine into the joint between the screen and the housing frame.
Scroll the outline of the phone to peel off the glue.
Avoid the area of ??the flex cable since you could cut it with the barb.
You should not use force as it could split or damage the screen. Repeat the previous step and apply heat as many times as necessary to remove it easily.
Separate the screen taking care that the flex cable does not bend or jam as it could break.
Take off the lower antenna module.
Carefully remove the flex from the vibrator.
Peel off the vibrator to separate the lower module.
Take off the lower antenna flex.
Remove and save the microphone coverage.
Take off the microphone.
Insert the HOT GLASS in the microwave for the time specified in the instructions for use.
If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.
The last minute in the microwave is advised to interrupt every 15 seconds and knead the gel inside with your hands to distribute the heat.
Apply heat to the screen for a couple of minutes.
Insert the tip of the tine into the joint between the screen and the housing frame.
Scroll the outline of the phone to peel off the glue.
Avoid the area of ??the flex cable since you could cut it with the barb.
You should not use force as it could split or damage the screen. Repeat the previous step and apply heat as many times as necessary to remove it easily.
Separate the screen taking care that the flex cable does not bend or jam as it could break.
Peel off the front buttons.
With tweezers, pass the front buttons to the opposite side.
Take off and separate the flex with vibrator, microphone and the bottom buttons.
