Characteristics:

Voltage: 36V.

Weight: 13Kg.

Max Speed: 10 Km / h.

We will start by removing the sixteen Phillips screws (PH # 2) that hold both lower housings.

This casing can not be removed yet, we will disconnect the wires from the LEDs of the casing and carefully remove it as it will continue to be attached to the cable of the charging connector.

In order to remove this casing, we will disconnect the cables from the components stuck to it. We disconnected the cable that connects the loudspeaker power plate and the base plate, the power button cable and the led lights.

In this step we will begin to disconnect all the components connected to the motherboard. We will also cut the flange that joins all the cables to facilitate the process.

In this step we will remove the four Phillips screws (PH # 2) that hold the plastic structure that holds the battery.

Now we remove the plastic piece and then disconnect the cables that pass over the battery to be able to remove it.

To remove the battery and only we have to disconnect and disarm.

In this step we will disconnect the motor cables from the side of the battery.

In this step we will do the same as in the previous step but on the side of the motherboard.

In this step we pull the cables that go inside the shaft to remove the plate.

We will also disconnect the charging connector.

To finish, we remove the four Phillips screws (PH # 2) that hold the plate to the chassis and we can remove it.