To separate the gimbal support, we will have to rotate the pieces as indicated in them.

Remove the screw covers and remove them. Then we unlock the side trims by prying.

We disconnect the flex that comes from the support and the one that comes out of the inside of the camera to be able to remove the plate.

Now we remove the screws of the hitch, remove the bearing and unhook the support.

We remove the screws that we find on each side of the camera and unlock the case by prying.

First we separate the back cover so we will have to disconnect the microphone.

We disconnected the antennas and pulled the chassis slightly to disconnect the flex from the camera sensor.

Now we can remove the front cover.

Finally, we remove the screws that hold the sensor plate and remove it. Now we can get the objective.