To begin, we must apply heat to the back cover, and with the help of a fine tool we will open a small hole through which we will introduce one or more plastic prongs, with which it will be less likely that we will damage the case.

We remove the twenty-one Phillips screws (PH # 00) that hold the intermediate housings, disconnect the flex from the rear flash that is attached to the housing, and with the help of a flat tool we will unhook the housings.

We disconnect the battery to work with greater safety.

We disconnect and extract the charging connector.

We disconnect and remove the interconnection flex.

We disconnect and remove the coaxial cables.

We disconnect and take off the flex bridge.

We disconnect the four connectors from the cameras and we can lift the module.

We extract the Phillips screw (PH # 00) that holds the shield that covers the camera connectors, and with the help of a tool we disconnect the front cameras.

We extract the Phillips screw (PH # 00) that holds the motherboard, disconnect the connectors that are connected to the motherboard, and with the help of a flat tool we will lift the motherboard.

We take off the flex with proximity sensor.

We remove the two Phillips screws (PH # 00) that hold the ignition button, and with the help of tweezers we will detach it.

We take off the battery.

We remove the card tray, and with the help of a flat tool we will remove it.

We extract the Phillips screw (PH # 00) that holds the speaker, and we will detach the speaker.

Finally we will take off the fingerprint reader from the damaged screen that we have to replace.