To start, we apply heat to the back cover to soften the adhesive that holds it, and with the help of a plastic spike we will take off all the edges of the case.

We disconnect the interconnection flex between the fingerprint reader and the motherboard with the help of an opening tool and tweezers.

Remove the twelve Phillips screws (PH # 00) that hold the intermediate housing and unhook it.

We will disconnect the battery to work with greater security, and also the interconnection flex between the fingerprint reader and the motherboard, to work with greater comfort.

We remove the eight Phillips screws (PH # 00) that hold the lower case and the speaker, and with the help of a flat tool we will unhook the lower case.

We remove the tray from the cards.

We disconnect and remove components.

We finish disconnecting the components that are connected to the motherboard, and we can remove the motherboard.

We take off the flex with the side buttons.

With the help of a flat tool we will take off the proximity sensor.

We remove the headset.

We remove the interconnection flex, the speaker, disconnect the coaxial cable from the auxiliary plate, and we can now unhook the auxiliary plate.

We take off the vibrator, and remove the coaxial cable.

Finally we remove the battery taking care not to damage it.