Before starting make sure the tablet is off.

Remove the plastic cap that covers the card readers on top.

Remove the 3 Phillips screws that hold the back cover.

Disassemble the back cover all the way around with the opening tool.

By separating the back cover it is possible that the speakers stick to it; If this is the case, remove them to separate the lid.

Disconnect the LCD data flex, by pulling on the tab of the connector and gently pulling the cable. Then take off the flex of the battery, held by adhesive tape.

Remove the adhesive covering the battery connector.

Disconnect the battery from the motherboard.

Unplug the flex at the end of the motherboard, by pulling on the tab of the connector and gently pulling the cable.

Remove the 2 Phillips screws that hold the auxiliary plate to the housing.

Finally, unsolder each of the 3 cables individually, at the end of the base plate.

To do this, apply heat with the tip of the soldering iron to the tin while gently pulling the wire.