Before starting, make sure the tablet is off.

Remove the SD card by opening the lid behind the holder.

Remove the 3 Phillips screws that hold the back cover. Note that you must remove the sticker that hides the 2 screws on the right.

To separate the back cover we recommend the opening tool type "cortapizzas".

The curved parts on both sides of the support tend to resist a bit. Use the flat end of the black opening tool to gently pry it off.

Unplug the flex from the camera on the motherboard and pull gently to detach it.

Unplug the data flex from the touch screen, by pulling on the connector tab and gently pulling.

Unplug the flex located on the left side of the tablet, including the battery.

Disconnect the interconnection flex with the auxiliary plate.

Disconnect the data flex from the display.

Remove the 6 screws that hold the motherboard and turn it over to the motherboard.

Disconnect the antenna coaxial cables on the motherboard.

Finally, remove the wifi antenna, held by 3 Phillips screws.