Before starting, make sure the tablet is off.

First, we must remove the card, after a small lid located on the side.

Remove the screw, covered by the warranty seal, located next to the SD card slot.

The screw is Phillips (PH # 00).

We remove the back cover by inserting a plastic opening tool and gently prying it all the way around.

To separate the screen we must disconnect the data flex from the motherboard, by actuating the tab of the connector and pulling gently.

Disconnect the camera from the motherboard by pressing the connector tab.

Remove the 2 Phillips screws (PH # 00) shown in the image.

Remove the small metal shield covering the battery connector and disconnect it from the motherboard.

Also remove the metal shield that covers the charging connector, held by 2 Phillips screws.

Separate the base plate by pushing gently from below with an opening tool.

Use antistatic protection to manipulate the plate with your hands.

Finally, disconnect the rear camera from the motherboard.