To start we must apply heat to the screen, for this we have used a thermal mat, and we have taken off all the edges of the screen with a plastic pick, and when we have already been able to lift the screen, we have verified that both in the upper part and in the lower one, the screen is connected to the motherboard by means of several flexes.

We remove all the Phillips screws (PH # 00) that hold the various shields that cover the connectors of the screen, and with the help of a flat tip tool we will disconnect them.

We remove the Phillips screw (PH # 00) that is in the battery connector, and with the help of a plastic pick we will lift the contacts a little, in order to work with greater security.

We remove the four Phillips screws (PH # 00) that hold the shield to be able to remove it.

We remove the two Torx screws (T3) that hold the camera module, with a flat tip tool we will disconnect them and we can now remove the module.