To begin with we will remove the two Pentalobe screws (TS1).

We extract the tray of the cards with the help of the extraction tool.

With the help of one or more barbs, we uncouple the entire side of the casing.

Remove the three Phillips screws (PH # 00) that hold the shield.

Disconnect the flexes that are connected to the motherboard, and remove the front camera.

Remove the two Phillips screws (PH # 00) that hold the motherboard and the antenna module.

Disconnect the two coaxial cables.

Before moving on to the next step, remember to remove the Phillips screw (PH # 00) that holds the motherboard.

We lift the motherboard, but we will have to disconnect from the back the flex connector with proximity sensor and microphone.

Take off the adhesives that are above the connectors of the cameras, and we can disconnect them and remove the module with the two cameras to place it on the new base plate that we have.