To begin with we will remove the two Pentalobe screws (TS1).
Step 2 Tray
We extract the tray of the cards with the help of the extraction tool.
Step 3 Back case
With the help of one or more barbs, we uncouple the entire side of the casing.
Step 4 Antenna module with loudspeaker
We extract the four Phillips screws (PH # 00) that hold the loudspeaker, and with the help of an opening tool we will disengage the loudspeaker antenna module.
Step 5 Auxiliary plate
Disconnect the coaxial cable, disconnect the flex from the front button, the interconnection flex that is connected to the underside of the auxiliary plate and we can remove the plate.
Step 6 Shielding and connectors
Remove the 3 Phillips screws (PH # 00) and unhook the shield, disconnect the interconnection flex and the battery.
Step 7 Drums
Pull the adhesive tape that is in the lower left of the battery, so we will get off all that side of the battery and so we can introduce a flat tool to finish taking it off.
Step 8 Front button with fingerprint reader
Remove the two Phillips screws (PH # 00) that hold the button shield and we will release the button.
Step 9 Components
We disconnect all the components that are connected to the motherboard.
Step 10 Motherboard
We extract the two Phillips screws (PH # 00) that hold the motherboard, and we must disconnect the flex of the proximity sensor and microphone from the back.
Step 11 Fullscreen
We take off the flex of the digitizer, apply heat to the screen, and with one or more prongs we will take off all the edges of the screen.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.