To begin with, we must apply heat to the back cover in order to soften the adhesive that holds it, and with the help of one or more plastic spikes we will peel off all the edges of the case.

We extract the eleven Phillips screws (PH # 00), which hold the intermediate casing that covers the motherboard area, and with the help of a flat tool we will unhook it.

We disconnect the battery to work with greater safety.

We removed all the rear cameras.

We also extract the front camera.

We disconnect and take off the rear flash.

It would not be necessary to remove the rear flash to remove the base plate.

We disconnect all the components that are connected to the motherboard, and with the help of a flat tool we can now lift the motherboard, being careful not to damage the pins.

We extract the card with the extraction tool, remove the four Phillips screws (PH # 00) that hold the reader area, and with the help of a flat tool we will remove it.

To detach the battery we will first detach zone A from the sticker that it has, then zone B from the sticker, and to detach it we will pull from zone A, so that it detaches more easily we can introduce a few drops of isopropyl alcohol around the edges battery to soften the adhesive.

We take off the rubber cover that covers the hole of the buttons, we take off the area of the contacts with the help of tweezers, and with a fine metal spike we take off the area of the buttons.

We extract the shield that protects the fingerprint reader and power button, we take off the flex and we will take it out through the hole in the module reader.

We take off and remove the headset.

With the help of a metal spatula we will take off the vibrator.

We extract the three Phillips screws (PH # 00) that hold the speaker, and with a flat tool we will remove it.

We disconnect and take off the two interconnection flexes.

We lift the auxiliary plate and disconnect the coaxial cable that is connected at the bottom.

Finally we only have to remove the coaxial cables and the bottom plate of the screen that we have to replace.