Before starting, make sure that the mobile is turned off.
Step 2 Back cover
Remove the back cover with the opening tool, this will avoid scratching the equipment.
Step 3 Battery
Remove the battery by pulling on the bottom.
Step 4 SIM and SD cards
Remove the SIM and SD cards.
Step 5 Intermediate housing
Remove the 10 Phillips screws from the intermediate housing.
Step 6
Separate the intermediate housing with the opening tool.
Step 7 Rear camera
Disconnect the rear camera from the motherboard by pressing the tab on the connector.
Finally, gently pull the camera to remove it.
Step 8 Front camera
Unplug and remove the front camera.
Step 9
Disconnect the interconnection flex.
Step 10
Unplug the display data flex.
Step 11
Take off the flex with volume pushbuttons and ignition of the chassis.
Step 12
Remove the Phillips screw that holds the motherboard.
Disconnect the data flex from the touch screen.
Step 13
Lift the base plate and disconnect the coaxial antenna cable to remove it.
Step 14 Light and proximity sensor
Disconnect the flex from the proximity sensor on the motherboard.
Remove it from the metallic shield.
Step 15 Motherboard
Next we will desoldaremos the flex of the pulsadores of volume and turned on.
We will protect the nearby components and connectors with the welding mask, so the heat will not melt them.
Step 16
Apply heat with the air nozzle of the soldadur station between 200 and 300 ºC. With tweezers fit, pull the flex very gently. It will gradually take off.
Finally, remove the remains of the mask.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.