To begin we must apply heat to the screen, and with the help of a suction cup we will open enough space to introduce a plastic spike and take off all the adhesive that is around the edges of the screen.

We extract the Phillips screw (PH # 00) that holds the shield that covers the connector of the screen, and once the shield is removed we can disconnect the screen.

We extract the fourteen Phillips screws (PH # 00) that hold the housing and the shield of the battery connector, disconnect the battery and with the help of a flat tool we will disengage the housing.

We disconnect and remove the front camera.

We disconnect the components that are connected to the motherboard, and remove the tray from the cards.

Remove the three Phillips screws (PH # 00) that hold the base plate to the housing and disconnect the interconnect flex from the back.

We extract the two Phillips screws (PH # 00) that hold the plate, disconnect the interconnection flex between both plates and we can take off the NFC plate and wireless charging.

We take off the shielding components of the plate to be able to remove it.

We disconnected the interconnection flex and the coaxial cable to be able to remove the motherboard.

We disconnect and remove the interconnection flex

We disconnected the rear camera.

Desoldamos the vibrator and the rear angle camera.

Finally we will disconnect the proximity sensor from the motherboard that we are going to replace.