Insert the HOT GLASS in the microwave for the time specified in the instructions for use.

If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.

The last minute in the microwave is advised to interrupt every 15 seconds and knead the gel inside with your hands to distribute the heat.

Before starting make sure the phone is switched off.

For the equipment to be water resistant, the back cover is attached.

Apply heat for a few minutes to soften the glue.

The cover is glued by an adhesive line that runs all the way around. Use the prong to detach it.

Remove the adhesive covering the flex cable from the battery and disconnect it from the board.

The battery is attached to the chassis. Pull a little of the white tape and finish separating it by pushing it from behind with the opening tool.

Remove the battery without deforming it as it could be damaged.

Remove the Phillips screw that holds the upper antenna.

Unhook the antenna and open the USB connector cover to remove it.

To remove the front camera, disconnect it from the motherboard and pull it out.

Remove the adhesive next to the small pad.

To remove the rear camera, disconnect it and gently pull it out.

Remove the SIM card next to the tray.

Remove the 2 Phillips screws that hold the plate.

Disconnect the flex cables from the motherboard.

Disconnect the upper end of the coaxial cable.

Remove the base plate with the opening tool.