We will start by removing the screen, for this we will warm it to about 60ºC during a minute approximately.

With the hot screen, we will introduce a tine or another flat opening tool and move it around the contour to remove the adhesive.

To remove the screen, we will disconnect it from the bottom.

Remove the ten Phillips screws (PH # 00) that hold the shield, disconnect the battery and remove it.

In this step we remove the lower plastic housing and the support of the coaxial cables.

We take off the auxiliary plate and disconnect it.

We remove the flex cable with charging connector and also the support of the coaxial cables.

It only remains to disengage the speaker module and take it off.