To begin with we must apply a little heat to the back of the phone, to take off the back cover more easily.

We extract the 7 Phillips screws (PH # 00), disconnect the flex from the top and the NFC antenna, and we can unhook the intermediate casing.

We disconnected the interconnection flex.

We remove the tray from the cards.

We extract the Phillips screw (PH # 00) that holds the module, disconnect the vibrator and we can remove the module.

We disconnect and remove the cameras from the phone.

Disconnect the remaining components that are connected on that side of the motherboard, lift the base plate carefully, because the bottom should disconnect two other flex that are covered by an adhesive.

Once the adhesive is peeled off, we can disconnect the two flexes and remove the base plate.

We take off the connector that we are going to replace, and we remove it without damaging the flex of the screen.