We started by heating the back cover at about 60 ° C for about 1 minute.

With it hot, we introduce a flat tool between it and the frame. Sliding it around the contour will get it off.

We remove the Torx T4 screws indicated in the first image and then disconnect the front camera, the flex of the battery and the flex of the charging connector.

We remove the casing from the top and remove the camera delanera.

Now we disconnect the flex from the rear camera, the flex from the side buttons, the charge connector, the audio connector and the coaxial antenna cable.

Remove the two Phillips screws (PH # 00) that hold the motherboard and disengage it.

It is recommended to remove the SIM / SD trays to remove the plate.

To finish, we remove the plastic support and disengage the audio connector.