To begin, we must apply heat to the back cover in order to soften the adhesive that holds it, and with the help of one or more plastic spikes we will take off all the edges of the case.

We disconnect the wireless charging coil, the NFC antenna, and we will remove the five Phillips screws (PH # 00) that hold the shield, and we can unhook the shield and take off the wireless charging coil.

We disconnect the module with the autofocus laser, led flash and rear microphone, and we will also disconnect the headphone connector, we will remove the four Phillips screws (PH # 00) that hold the module, and with the help of a flat-tipped tool we will remove it .

We disconnect all the components that are connected to the motherboard.

We remove the Phillips screw (PH # 00) that we show in the first photograph of this step, and we will be able to lift the motherboard carefully.

We disconnected the cameras and the telephoto lens from the motherboard.

We extract the Phillips screw (PH # 00) that joins the rear camera module with the telephoto lens that we have to replace.