We start by applying heat to the back of the terminal to be able to remove the battery cover

Then we remove the sim tray and then with the help of a thin plastic tool we introduce it and begin to take off the battery cover all around its contour until it is separated.

We take off the NFC antenna and wireless charging from its lower part to be able to extract the intermediate housing

With a Phillips type screwdriver (PH # 00) we extract the nine screws and remove the intermediate casing from its housing.

With a fine tool we release the NFC antenna connector and wireless charging

Then we disconnect the battery to avoid any type of incident.

In this step we will release all the connections that are on the motherboard to be able to remove it.

With a Phillips type screwdriver (PH # 00) we loosen the fixing screw of the base plate and with a fine tool we can extract the base plate from its housing.

Next we extract the seven Phillips type screws (PH # 00) that hold the speaker and with a fine tool we extract it.

We disconnect all the connections that are on the auxiliary plate to be able to remove it.

We extract the vibrator with the help of a fine tool from its place

Next, with a fine tool, we extract the shield from the pushbuttons and remove it, which brings the side pushbuttons with them, then we detach the felx from the side pushbuttons with a fine tool and once detached we can remove the pushbuttons from their housing.

Once the side buttons have been removed, we will remove the keys by pushing them from the inside to the outside with a fine tool.

We go back to the bottom of the terminal and remove the fingerprint reader, using a fine tool to take it off its housing.

Finally, we remove the battery with the help of a battery extraction tool, lifting it little by little from its housing and we will have the screen free of components.