To begin, we will apply heat to the back cover with a hot air gun, and using one or more plastic spikes we will take off all the edges of the case.

We remove the eleven Phillips screws (PH # 00) that hold the housing, and with the help of a flat tip tool we will unhook it.

To work with greater security we will disconnect the battery.

We remove the tray from the cards.

We remove the seven Phillips screws (PH # 00) that hold the speaker, and with the help of a flat tool we will unhook it.

We disconnect all the components that are connected on the motherboard.

We remove the two Phillips screws (PH # 00) that hold the motherboard, and with a flat tip tool we will remove it.

We take off the speaker contacts area with flat tweezers, and with a thin tool we will take off the speaker.

We take off and remove the headset and the vibrator.

Remove the flex puete that joins the two plates, and disconnect the other flex that is connected to it from the auxiliary plate.

We unhook the auxiliary plate.

We remove the flex with the charging connector.

We take off the fingerprint reader.

We take off the battery with the help of the adhesive that it has on one of the sides, but we will take it off taking care not to damage it too much.

We remove the coaxial cable.

We remove the Phillips screws (PH # 00) that holds the antenna module, and we will take it off.

To finish we will only have to take off the other flex bridge that is glued by the side of the chassis.