We start by removing the screen. For this we heat it to about 60ºC for about a minute.

With the hot screen, we slide a flat tool around the contour to take it off. We will try not to bend it much and we will not approach the display to avoid damaging it.

Once detached, we will open it as a book to disconnect the flex from the home button and the screen button.

Remove the fifteen screws that hold the upper and lower housings and disengage them. Then we remove the SIM / SD tray.

In this step, we disconnect the battery and remove the three T3 Torx screws that hold the plate. We will take off the rear camera and the flex of the SIM / SD card reader to finally disengage it.

We remove the mass contact from the rear camera and then take off the flash module from the rear camera.