With a SIM removal tool, remove the SIM tray.

We heat the terminal with a thermal mat at 80º for a minute and a half.

We introduce an opening tool between the back shell and the terminal to be able to introduce then a plastic spike and make, with care, the contour, taking off the back cover.

With an opening card we just separated the back cover.

Unscrew the Phillips screws (PH # 00) that hold the metal plate that covers the connector of the fingerprint reader.

We remove the metal sheet. We disconnect the flex from the fingerprint reader.

Unscrew the Phillips screws (PH # 00) that hold the intermediate housing with the terminal. We remove it.

We disconnected the flex from the battery.

We take off the battery introducing an opening tool. We will be careful not to hook the flexes of the screen and the interconnection flex so as not to break them.

We took the battery completely and removed it.

We disconnect the flex from the screen.

We apply heat with a thermal mat at 80º for two minutes.

We introduce a metal pick between the screen and the frame. Once introduced, we change it by a plastic spike to make the contour without scratching the screen or the frame.

We do all the contour, taking off the screen of the frame.

We take off the screen of the frame.

We take off the flex of the intermediate shell and repeat the screen.