First we apply heat to the back cover to soften the adhesive that holds it, we introduce a thin tool with which we will open a small hole to introduce one or more plastic spikes, and thus we will not run the risk of not damaging the back cover.

We disconnect the interconnection flex from the fingerprint reader.

We remove the eight Phillips screws (PH # 00) that hold the intermediate housing and unhook it.

Remove the Phillips screw (PH # 00) that holds the shield, and we will take off the black adhesive that is above the battery.

We disconnect the battery connector to work with greater security, and the interconnection flex of the fingerprint reader to work with greater comfort.

We remove the card tray and disconnect the interconnection flex and the screen flex.

We remove the cameras, disconnect the coaxial cable and we can remove the motherboard.

We take off the area of the contacts, and with a fine tool we take off the flex with the side buttons.

We remove the front flash plate and take off the headset.

We take off the battery and the adhesive that surrounds it.

We remove the seven Phillips screws (PH # 00) that hold the speaker module, and with the help of a flat tool we unhook it.

We remove and disconnect the coaxial cable, and take off the interconnection flex.

And finally we have taken off the auxiliary plate of the screen that we are going to replace.