We apply heat to the back shell, and with the help of a pick we will remove all the edges of the back shell. Once the edges are detached we will have to disconnect the interconnection flex from the fingerprint reader.

We extract the eleven Phillips screws (PH # 00) that hold the intermediate housing, remove the adhesive that is above the battery. and we can remove the intermediate casing.

We disconnected the battery to avoid possible damage.

We disconnect the interconnection flex from the fingerprint reader and the adhesive that is located above the battery.

We extract the eight Phillips screws (PH # 00) that hold the module, and with the help of a flat tool we will disengage the module.

To finish, with the help of flat tweezers we take off the vibrator that we are going to replace.