We apply heat to the back casing and with the help of a plastic plectrum let's take off all the edges of the casing.

We remove the Phillips screw (PH # 00) that holds the shield that protects the battery connector.

Remove the 15 Phillips screws (PH # 00) that hold the intermediate housing and with the help of a plastic prong we uncouple the housing.

We disconnect all the components of the motherboard.

Disconnect the components, remove the card tray, remove the Phillips screw (PH # 00) that holds the motherboard and remove it.

By using a tool that is fine enough, we have used a metal pick, we extract the sensor that we are going to change.