To begin we will have to extract the tray of the cards.

We will remove the 2 Torx screws (T3) from the lower part of the casing, and with a metal spike we will unhook the whole casing. Once we take it out we will have to disconnect the flex from the fingerprint reader.

Remove the Phillips screws (PH # 00) and the shield above the connector. Then we disconnect it, take it off and remove it.

Simply disconnecting the flex would be enough, we have preferred to remove it.

Remove the Phillips screws (PH # 00) that hold the shield that is above the connector of the coaxial cable, the battery and the interconnection flex, we must also disconnect the flex from the screen.

We will remove the 5 Phillips screws (PH # 00) that hold the base plate and we can remove it.

We remove the coaxial cable and the interconnection flex.

We extract the auxiliary plate, the speaker module and the battery.

We apply heat to the screen, and take off the flex and with the help of a plastic spike we will take off the screen little by little without damaging the frame.