We started by heating the screen at about 60ºC for about a minute.

Once hot, we introduce a tool between it and the housing and sliding it around the contour, we will take it off.

Remove the two Phillips screws (PH # 00) that hold the shield and remove it to disconnect and remove the screen.

In this step, we remove the nine Phillips screws (PH # 00) that hold the intermediate casing and disengage

We disconnect the interconnection flex from the auxiliary board, disconnect the coaxial cable that passes over the speaker module and disconnect the speaker to remove it.

Remove the Phillips screw (PH # 00) that holds the auxiliary plate and then take it off the chassis. All you have to do is desolder the vibrator.