We start by removing the back cover. For this, we will use an opening tool, which we will introduce between it and the frame to unhook it.

We remove the six Phillips screws (PH # 00) that hold the shield and remove it.

Now we can disconnect the screen.

We remove the six Phillips screws (PH # 00) that hold the speaker module and remove it.

Below the module we disconnect the interconnection flex, which is the same as that of the screen.

We heat the screen at about 60ºC for about a minute to soften the glue.

We introduce a barb or other flat tool between the frame and the screen. Sliding it around the contour, we will take off the screen.