Before starting make sure that the equipment is turned off.

Remove the SIM card using the removal tool.

Remove the 2 Pentalobe screws that secure the front panel to the housing.

In this model, unlike its predecessors, the opening suction cups are not going to be as useful, as it has a small strip of adhesive to ensure the tightness of the equipment.

Instead, we will use a suction cup and while we pull the screen, we review the outline with the flat part of the plastic stick.

Little by little, starting from the bottom, we will take off the front panel.

Remove the metal cover that covers the connections of the screen held by 4 Phillips screws ..

Unplug the flexes on the motherboard to separate the screen.

Remove the metal shield covering the connections, secured by 2 Phillips screws.

Unplug the battery connector.

To remove the battery we have to remove the stickers that are underneath. Pull the adhesive protruding from the bottom of the battery and pull it to the side. Continue until it is completely removed and repeat with the other side.

To install a new battery you will need to replace the adhesive.

Remove the screws indicated in the photos.

Remove the metal shield from the connector.

Remove the upper antenna and the shield of the rear camera.

Unplug the rear camera and pull it gently to remove it.

Remove the small contact located to the right of the camera.

Disconnect the lower flex, the two ends of the coaxial cable and the upper flex.

Remove the screws that hold the base plate.

One of the screws has a hexagonal thread. As it is not usual to have heads for this type of screws we will unscrew it with the head that appears in the photo, although small pliers would also be worth.

Use antistatic protection if you are going to handle the plate with your hands.

Remove the motherboard.

Unhook the coaxial cable from the side of the plate by pulling gently.

Remove the screws that secure the metal brackets.

Separate the supports.

Remove the metal shield secured by a Phillips screw.

Take off the flash and microphone carefully.

Finally, take off the flex by pulling gently.