First, we apply heat to the terminal on the screen part to soften the adhesive and be able to separate them.

Next we extract the two Pentalobe type screws (TS1) and with the help of suction cups and a fine opening tool we separate the screen from the terminal until it is detached from the chassis

We remove the Triwing screws (Y0.6) from both shields that are shown in the first photo of this step and remove them.

Now we disconnect the battery and the flexes that join the screen to the terminal chassis in order to separate them.

We extract the four Triwing type screws (Y0.6) and one Phillips type (PH # 00), remove the shield, then loosen the connections of the cameras with a fine rear tool and remove them.

We extract two Triwing type screws (Y0.6) and one Standoff type to remove the plastic casing

Next we remove the two Triwing type screws (Y0,6) and detach the flex from its base until the flash with microphone is released.