To begin, we must remove the two Pentalobe 0.8 (TS1) screws from the bottom of the housing, apply some heat to soften the adhesive, and with the help of a tool with suction cups we will take off the chassis screen.

We disconnect the battery connector to work with greater safety.

We remove the five Triwing screws (Y0.6) that hold the shield, and once removed we can disconnect the flex from the screen and the headset module.

We remove the card tray.

We remove the three Phillips screws (PH # 00) and the female flat screw that holds the shield, and with the help of a flat tool we remove the card reader.

We disconnect all the components that are connected to the motherboard, remove the flat female screws that hold the shield, and disconnect the flexes that are connected to the motherboard under the shield.

Finally we can remove the motherboard that we have to replace.