Using a plastic opening tool, remove the back cover.

Using the necessary tools remove all the cards from the phone.

Remove the 13 Phillips screws (PH # 00).

Unhook all the edges of the intermediate casing, for this use a plastic opening tool.

Remove the Phillips screw (PH # 00) that holds the battery, lift the battery with an opening tool, and simply lifting the battery will disconnect itself.

Disconnect all components of the auxiliary plate, remove the vibrator, disconnect the flex cable and remove the coaxial cable, use all the necessary opening tools and clips. Remove the two Phillips screws that hold the auxiliary plate (PH # 00).

Unplug the interconnection flex from its two ends and proceed to detach it little by little with a plastic tool.

Peel off the vibrator, remove the auxiliary plate and the base plate.

Peel off the side buttons of the telephone chassis with a pick, then insert a metal opening tool through the flex hole to detach it completely.

Take off the receiver with a prong, and lift off the digitizer flex.

Remove the two stickers that are holding the display to the phone's chassis, and detach the flex from the display with the help of an opening tool.

Apply heat to the screen, for this you can use a hot air gun, a heat blanket or a thermal mat.

If you use a heating blanket, CAREFULLY READ the instructions for use.

With a plastic spike, lift the display and the digitizer at the same time, carefully remove all the edges of the screen without damaging any flex.

Take off with a card the digitizer that you want to change the display.